Zodiac Rear Pulley to Wheel Spacer

This very complete swingarm conversion kit enables you to mount a 200 wide tire in the stock frame and still keep the stock drive belt without any trimming. Each kit includes the right parts and hardware for the right years, check carefully what you need before ordering. Due to the extra width of this kit the stock fender and fender struts can no longer be used, extra wide aftermarket fenders and struts must be used. Where applicable the original struts must be cut-off and replaced and replaced by bolt-on type fender strut ZPN236499. Also on some models it may be needed to grind down the square bottom bar support to clear the shock absorber eyes. Zodiac offers up-to 11" (28cm) rear fenders in the fender section of this catalog. Each kit includes: Off-set swingarm, wheel adjuster set, wheel axle spacers, wheel axle, off-set transmission plate, primary spacer, longer inner primary mount bolts, crankshaft extension, extended crankshaft nut and a primary gasket kit with extra O-ring. A special triangle shaped transmission side mount plate eliminates the use 5th transmission stud and allows the use of the OEM and all aftermarket shock absorbers. All parts are separately available.

Individual parts, Rear pulley to wheel spacer

Rear pulley to wheel spacer

• Category: Swingarms